Extreme Networks BlackDiamond 8810, Руководство по установке оборудования

Страница: 96 / 162

BlackDiamond 10K Series I/O Modules
Extreme Networks Consolidated XOS Hardware Installation Guide
96
Verifying the I/O Module Installation
After you install an I/O module, verify that it is working correctly. Check the LEDs on the front panel
of the I/O module and use the command line interface (CLI)
show slot <slot number>
command to
display slot-specific information about the newly installed module.
LED Indicators
When the I/O module and its ports (if applicable) are configured and operating normally, the front-
panel LED indicators should appear as follows:
●
STATUS LED—green blinking
●
DIAG LED—off
●
Port status LED (per port):
For more information about I/O module LED activity, see “I/O Module LEDs” on page 93 .
Displaying Slot Status Information
Assuming the I/O module has no problems, the command
show slot <slot>
(where <slot> is the
number of the slot where you installed the module) displays information about the module including:
general information about the module (name, serial number, part number), the state of the module
(power down, operational, mismatch between the slot configuration and the module in the slot), and
the number of ports on the module.
For more information about slot status information, see the ExtremeWare XOS Concepts Guide and the
ExtremeWare XOS Command Reference Guide.