Extreme Networks BlackDiamond 8810, Руководство по установке оборудования

Страница: 70 / 162

BlackDiamond 10K System Chassis
Extreme Networks Consolidated XOS Hardware Installation Guide
70
Mid-Mount Rack Installation
To mount the BlackDiamond 10K series switch into a standard 19-inch (48.26 cm) rack using the mid-
mount kit, you need the following tools and equipment:
●
Helper bracket (provided)
●
A minimum of four appropriate screws to secure the helper bracket (not provided)
●
Mid-mount kit
●
# 2 Phillips screwdriver
●
A minimum of two people to help install the chassis into the rack
To mount the chassis into a rack:
1 Place the box that contains the chassis upright on a secure flat surface with the front of the box
facing you.
2 Remove the chassis from the box, following the uncrating procedure described in “Unpacking the
Chassis from the Carton” on page 66 .
3 Secure a mid-mount kit flange to each side of the BlackDiamond 10K series switch chassis using the
provided screws.
Ensure you are using the appropriate flange for the left and right side, as shown in Figure 30 .
Figure 30: Mid-mount flange for the BlackDiamond 10K series switch chassis
EX_075
Midmount flanges