Extreme Networks BlackDiamond 8810, Руководство по установке оборудования

Страница: 82 / 162

BlackDiamond 10K Series Management Switch Module
Extreme Networks Consolidated XOS Hardware Installation Guide
82
NOTE
Use the metal panel, not the PCB, to guide the MSM.
As the MSM begins to seat in the chassis, the ejector/injector levers begin to close.
b
To close the ejector/injector levers, use both hands simultaneously to push the handles toward
the center of the module.
c
To secure the module, tighten the two screws with a #1 Phillips screwdriver.
NOTE
Tighten the screws of this module before you insert additional modules. Otherwise, you might unseat modules
that you have not secured.
d If you install a backup MSM, use the
synchronize
command to replicate all saved images and
configurations from the primary MSM to the backup MSM.
You are not prompted to synchronize the images and the configurations from the primary to the
backup. If not synchronized, the backup uses its image and the primary configuration. This
image/configuration mismatch will likely cause the switch to operate differently after failover.
CAUTION
Depending on the size and complexity of your network, you should install and configure a backup MSM when
network disruption will be minimal. You may need to reboot your switch after you use the synchronize command.
10 Store the module packaging for future use.
To install additional MSMs, repeat steps 1 through 10.
NOTE
Leave the ESD-preventive wrist strap permanently connected to the chassis so that it is always available when you
need to handle ESD-sensitive components.
Verifying the MSM Installation
After you install the MSM, verify that it is working correctly by checking the LEDs on the front panel of
the MSM. If it is operating normally, the front-panel LED indicators appear as follows:
●
SYS LED—Green blinking
●
MSTR LED:
■
Green: Operating as primary
■
Amber: Operating as backup
●
ENV—Green
●
ERR—Off
●
Link/Activity:
■
Green: Link is up.
■
Amber: Packet activity is occurring.