Extreme Networks BlackDiamond 8810, Руководство по установке оборудования

Страница: 129 / 162

Installing Aspen 8810 MSM and I/O Modules
Extreme Networks Consolidated XOS Hardware Installation Guide
129
Installing an Aspen 8810 MSM or I/O Module
Follow these steps to ensure proper installation of an MSM or I/O module:
1 Attach the ESD-preventive wrist strap, that is provided, to your wrist and connect the metal end of
the ESD-preventive wrist strap to the ground receptacle that is located on the top-left corner of the
chassis.
2 Remove the blank front panel if applicable.
3 Pull the ESD bag off of the module:
a Place the ESD bag containing the module on a flat ESD surface, clean from any debris.
b Break the quality seal and the ESD warning seal.
c Open the ESD bag and firmly grasp the rail of the module.
d Pull the ESD bag off while holding the rail of the module.
CAUTION
To prevent ESD damage, hold the module by the metal rail and front panel only. Never touch the components on
the PCB or pins on any of the connectors.
4 Prior to inserting the module, ensure that the module injector/ejector handles are open as shown in
Figure 70 .
Figure 70: Injector/ejector handles are shown in opened position
5 Slide the module into the slot using the injector/ejector handles in the open position.
CAUTION
Do not slide the module into the open slot if the injector/ejector handles are latched.
6 Latch the injector/ejector handles, using both hands, by simultaneously pushing both handles
toward the center of the module as shown in
Figure 71 .
ASP001B