Extreme Networks BlackDiamond 8810, Руководство по установке оборудования

Страница: 121 / 162

I/O Modules
Extreme Networks Consolidated XOS Hardware Installation Guide
121
I/O Modules
This section describes the Aspen 8810 switch I/O modules, including:
●
G24X Module on page 122
●
10G4X Module on page 123
●
G48T Module on page 124
●
G48P Module on page 125
No configuration information is stored on the I/O modules; all configuration information is stored on
the MSM(s).
When the Aspen switch is powered on, the software generates a default configuration for any slots that
contain I/O modules. The default configuration allows the I/O module ports to participate in the
VLAN named default. The default configuration for the I/O module is not preserved unless you
explicitly save the configuration to nonvolatile RAM (NVRAM).
You can configure parameters of the I/O module after it is installed or you can preconfigure a slot for a
certain type of module and configuration. The preconfigured information is applied to the module after
it is inserted. If you preconfigure a slot for a specific module type and then insert a different type of
module, the module reverts to its default configuration.
NOTE
See the ExtremeWare XOS Concepts Guide and the ExtremeWare XOS Command Reference Guide for more
information about configuring the modules.