Elsner KNX S1-B2 230 V, Установка и настройка

Страница: 70 / 77

68 Parameter setting
Actuators KNX S4-B10, KNX S2-B6 and KNX S1-B2 230 V
Status: 18.04.2017 • Technical changes and errors excepted.
The function can be used for example for a light, which is turned on when pressing a
"panic button" (=trigger for blocking function) and cannot be turned off any longer.
4.3.2.4.Scenes (switch functions)
The ‘Scenes’ menu item only appears in the settings of the switch function channel if
‘Use scenes: yes’ is selected.
For each drive, you can save different movement positions as scenes, and be able to
call them via the bus. 16 scenes are available per drive.
You can assign each activated scene its own scene number, regardless of the intenal
number of the actuator.
4.3.3. Button input (switch functions)
The inputs 1 and 2 of KNX S1-B2 and the inputs from 3 upwards of KNX S2-B6 and
KNX S4-B10 are designated for operating the devices on the outputs (channels) and
are therefore parametrized directly in the settings of the output channels. They can be
used as actuator button or bus button.
Input as bus button
The setting corresponds to input 1/2(see Input as bus button , page 40)
Input as actuator button
If the input to the control of the device is used at this channel, then specify the button
function.
Blocking function blocks for 0 • 1
Value of the blocking object
after bus voltage returns 0 • 1
Response when blocking no change • opened • closed
Response upon release follows switch command • opened • closed
Use scenes no • yes
Scene number 0...127
Switching status • inactive
• activ
Operating mode
Use input 3 / 4 / 5 / 6 / 7 / 8 / 9 / 10 • No
• as a bus button
• as an actuator switch
Button function Switch• Selector switch