Elsner KNX S1-B2 230 V, Установка и настройка

Страница: 67 / 77

65 Parameter setting
Actuators KNX S4-B10, KNX S2-B6 and KNX S1-B2 230 V
Status: 18.04.2017 • Technical changes and errors excepted.
Input as bus button
The settings correspond to input 1/2 (see Input as bus button , page 40)
Input as actuator button
If this channel is used for the input to the control of the drive, then specify the button
function and the control mode.
*A detailed description of the setting options for the individual control modi can be
found in the general part of chapter
Control modi for drive control , page 70.
The input can be blocked using a blocking object. No operation is possible for an active
block.
If monitoring periods or movement range limits are used, no operation via the local
button is possible in case of a bus voltage failure.
Input as zero position sensor
The zero position sensor is used for the movement range limit of the respective drive
(see
Channel settings – drives , page 45). In case of a defect zero position sensor a mal-
functioning message can be sent to the bus.
4.3.2. Channel settings – switch functions
If two switchable devices are connected to the output channel, two separate channels
will appear (e.g. "Channel A1 – switch function" and "Channel A2 – switch function").
First set the general specifications for the connected device and, if necessary, activate
the connections, time functions and blocking objects. A diagram is found in chapter
Correlation connection – time switch – block , page 74.
Button function Up • Down
Up • Down • Up/
Down
On • Off • On/Off
Open • Closed •
Open/Closed (shutter)
(blind)
(awning)
(window)
Control mode* • Standard
• Standard inverted
• Comfort mode
• Dead man's switch
Use blocking object No • Yes
Send malfunction message when zero
position sensor is defective No • Yes