Elsner KNX S1-B2 230 V, Установка и настройка

Страница: 47 / 77

45 Parameter setting
Actuators KNX S4-B10, KNX S2-B6 and KNX S1-B2 230 V
Status: 18.04.2017 • Technical changes and errors excepted.
• On/Off switch delays or time switching
(see
On/Off switch delays, time switching (switch functions) , page 66)
• Block function(see Blocking function (switch functions) , page 67)
• Button input: Configuration as actuator button or bus button
(see
Button input (switch functions) , page 68)
4.3.1. Channel settings – drives
If a drive is connected to the output channel, set first the general specifications for the
drive.
Driving direction:
Up/down, on/off or open/close can be exchanged.
Runtime:
The runtime between the end positions is the basis for moving into intermediate posi-
tions (e.g. for movement range limits and scenes). You can enter the runtime numeri-
cally (in seconds) or have the runtime determined automatically. The actuator specifies
the end positions with help from the greater current on the drive output. For this, regu-
lar reference movements (see below) should be set.
If a dead time is observed while starting the curtain, then this can be entered manually
at this point or calculated automatically. Obey the manufacturer's instructions for the
curtain.
Exchange UP/DOWN (shutter, blinds)
Exchange ON/OFF (awning)
Exchange OPEN/CLOSE (window)
no • yes
Use an automatic runtime measurement no • yes
Use an automatic runtime measurement no
Runtime DOWN in sec (shutter, blinds)
Runtime OFF in sec (awning)
Runtime UP in sec (window)
1 … 320; 60
Runtime OPEN in sec (shutter, blinds)
Runtime ON in sec (awning)
Runtime CLOSE in sec (window)
1 … 320; 65
Use dead times • no
• yes, enter by hand
• yes, calculate automatically
during the position travel from closed
position in 10 ms
(only for manual input)
0 ... 600
for position movement from all other
positions in 10 ms
(only for manual input)
0 ... 600
for slat movement from closed
position in 10 ms
(only for manual input)
0 ... 600