Elsner KNX S1-B2 230 V, Установка и настройка

Страница: 41 / 77

39 Parameter setting
Actuators KNX S4-B10, KNX S2-B6 and KNX S1-B2 230 V
Status: 18.04.2017 • Technical changes and errors excepted.
4. Parameter setting
The default settings of the parameter are labelled by an underscore.
4.1. General settings
First set the general parameters for the bus communication (telegram rate, transmissi-
on delay). Additionally, you can indicate if for the programming of scenes all, or only
the changed settings are applied to the bus.
4.1.1. Local operation
The Up/Down buttons on the device are firmly assigned to the channels A-D. For
blocking manual operation, blocking objects can be set for the button pairs
(communication objects "Channel X local operation blocking object").
Note: If monitoring periods or movement range limits are used, operation via the local
buttons is not possible in case of a bus voltage supply failure.
4.2. Inputs
Only for S4-B10 230 V and KNX S2-B6 230 V. For KNX S1-B2, button inputs are directly
parametrized in the settings of the output channels.
Set the parameters for inputs 1 and 2 of KNX S4-B10 and KNX S2-B6. The additional
inputs are designated by default for operating the devices on the outputs (channels A-
D), and are therefore parameterized directly in the settings of the output channels (see
Scenes (drives) , page 64) or (see Button input (switch functions) , page 68).
Maximum telegram rate 1 • 2 • 5 • 10 • 20 telegrams per second
Send delay of threshold values
after voltage returns 5 s … 2 h
Send delay of switching and status
outputs after voltage returns 5 s … 2 h
For the use of scenes:
Application when programming all parameters • only changed parameters
Local button Channel A
Use blocking object No • Yes
Local button Channel B
Use blocking object No • Yes
Local button Channel C
Use blocking object No • Yes
Local button Channel D
Use blocking object No • Yes