Eliet Turfaway 600, Руководство пользователя

Страница: 68 / 88

68
English
III. Bearings
The bearings used in the machine are dust tight and contain lubricant for life-long lubrica-
tion. However, it is still advised to provide lubricant in the friction zones between the seal and
the lubricant canister to prevent wear here too. Lubrication in these zones will also act as
protection from the dust that penetrates here.
The following bearings are fitted in the machine:
1. Bearings on the angle gear box (3x)
2. Bearings for blade holder hinge (2x)
3. Bearings in the connecting rod (4x)
4. Bearings in the tensioning rollers track (4x)
5. Bearings in the tensioning rollers (4x)
• To access the bearings you must remove the relevant guards.
• Prior to re-lubricating the bearings they must be cleared of old lubricant and deposits as
much as possible. Cleaning spray aimed at the bearings and in the bearing joints will do the
job easily. ELIET recommends NOVATIO KLEENSPRAY-S.
• Allow to work for several minutes so that the dried lubricant can soak off.
• Blow into the bearing joints with compressed air and brush off all deposits and cleaning agent.
• Repeat the above procedure if not all dirt was removed.
• Check that the bearing does not show excessive play. Also check that the bearing runs
smoothly. In the event of defects, consult your ELIET dealer for a bearing replacement in
order to avoid future damage.
• Re-apply a high quality lubricant. Spray this into the joints of the bearing seal. Use the lubri-
cant listed in “11.3. Lubricants” on page 61.
• Wipe away any excessive lubricant.
• After lubricating, replace the protective covers as they were originally fitted.
4 5
1 2 3