Eliet Turfaway 600, Руководство пользователя

Страница: 62 / 88

62
English
11.3. Lubricants
11.4. Routine check after each operation
11.4.1. Cleaning the machine
The machine should be cleaned as quickly as possible after the working session. Since the
Turfaway works in soil, dirt will mainly be caused by earth sticking in the area around the blade
and blade drive and in the zone around the tracks. In addition, sand and soil dust can remain in
openings and cavities or collect on machine parts or in lubricants. Hinges, rubbing surfaces and
cable guides are most disrupted by this. Therefore, you must clean these zones in particular.
“9.8.1. Cleaning the machine” on page 43
11.4.2. Visual check of the state of the machine
It is essential to inspect the machine after every use. This means that breakage and wear can be
discovered early on. Then, the required repairs can be carried out to ensure that the machine
remains in good condition ready for the next use. Some points deserve special attention:
• Check the state of the blade (both the horizontal and the vertical part). This must be replaced
as soon as distortion or breakage is identified (order number BU 105 041 150). If the cutting
edge has become blunt this must be sharpened. (read § 11.5.4; page 72)
• Check whether the bolts attaching the blade are still tight.
• Check the entire power train for the blade. In doing so you must check whether machine parts
have come loose and for traces of wear or corrosion.
• Check for slack or excess tolerance on moving machine parts (e.g. driving rods, blade carriage,
locking bolts, operating rods, etc.)
• Check that the protective covers are securely fastened.
• Check there are no visible leaks in the hydraulic power train.
• Check that cables can move properly in their ducts and work properly when activated.
Engine MOBIL DELVAC MX 10W30
Hinges NOVATIO PTFE OIL
Lubrication nipples MOBILGREASE XHP222
Cables and cable guides NOVATIO PTFE OIL H1
Bearings NOVATIO CLEAR LUBE-S
Hydraulic oil MOBIL UNIVIS N32