Eliet Turfaway 600, Руководство пользователя

Страница: 49 / 88

49
English
rounding area must be cleaned and lubricated.
• Remove dirt from the chassis and more specifically from the stickers with safety instructions.
• All soil attached to the blade must be brushed off and the blade must be cleaned.
• Use a dry cloth or soft brush for any cleaning. Use penetrating oil with MoS2 to remove grease
and lubricants. The spray is a lubricant and rust solvent at the same time.
• Where possible, use compressed air to clean machine parts or areas that are difficult to reach.
• Stubborn sticky dirt must be soaked with water to make it easier to brush off.
• The manufacturer does NOT recommend use of a high-pressure cleaner. The high-pressure
water jet reaches places where water should be avoided. The force of the water jet can pierce
seals and dust guards. Water is the number one cause of rust and this must be avoided at all
times.
• Clean the air filter.
Any necessary replacement and/or repair works must be undertaken immediately. Ask your
authorised ELIET dealer to carry out repairs (find an authorised ELIET dealer near you at
www.
eliet.eu ).
9.9. Lifting the machine
The machine has a hoisting eye that can be used to lift it with a crane of hoist, to take it to places
that are otherwise inaccessible in the normal manner. When conducting certain maintenance it
is necessary to lift the machine onto a work bench. This can be done with hoist or the hoisting
equipment of a forklift.
Warning: when lifting, make sure that the machine does not hook onto the ope-
rator and cause him to fall. Wear closely fitting work clothes. Always make sure
that the machine does not land on a foot when being returned to the ground.
Keep a sufficient distance and wear sturdy work shoes with a steel cap.
• Place the machine under the hoisting equipment. Make sure that the cable, chain or hoisting
strap of the hoisting equipment are always vertically above the hoisting eye. This will prevent
the machine from swinging as it is hoisted.
• Always turn off the engine before hoisting the machine.
• Check whether the 4 M8 bolts with which the hoisting eye is attached are firmly tightened (ring
wrench size 13).
• Attach the hook in the hoisting eye. Choose a sufficiently large hook so that the safety catch on
the lifting hook closes nicely after hooking in. When using the hoisting strap you must inspect
the strap for any damage. Slide the hoisting strap through the hoisting eye. Make sure that the
hoisting strap is not twisted.