Eliet Turfaway 600, Руководство пользователя

Страница: 69 / 88

69
English
IV. Lubrication nipples
The machine is fitted with only two lubrication nipples. These are fitted on the guide bushings
on the blade drive and are there to lubricate the most intensive movement.
• The lubrication nipples are accessed via the bottom of the machine.
• Use a lubrication pump to slowly pump extra lubrication grease into the bushings. Use the
lubricant shown in the list in “11.3. Lubricants” on page 62.
Caution: Stop as soon as pressure is felt when pumping. You must avoid forcing
the cap seals out of position.
• Lubrication flowing back out of the lubrication nipples when removing the pump hose must
be wiped away with a cloth.
V. Cables and cable guide
The machine has three operating cables. These pay a crucial role in the machine's operation.
It is therefore important that these cables lie properly in the cable guide.
Remove the protective covers to make the complete cable route accessible.
• When lubricating, the ends of the cable guides should always be wiped clean.
• Then spray MoS4 based penetrating oil into the ends of the cable guide and allow it to pene-
trate.
• Press the levers repeatedly so that the cable moves back and forth in the guide.
• While moving the levers, spray small amounts of penetrating oil on the highest end of the
cable guides.
• Repeat this for a few minutes until the penetrating oil on the underside of the cable guide
drains out.
• Now blow with compressed air into the highest end of the cable so that the penetrating oil is
forced out and the dirt in the guide is removed.
• Wipe off any dirt on the underside of the guide.
• Leave the machine for 30 minutes so that all the penetrating oil has drained out of the guide.
• After wiping away the penetrating oil, spray some new lubricant on the cable and in the guide
end while again operating the levers.
• Repeat this so that sufficient amounts of new lubricant can penetrate the cable guides.
• After lubricating, replace the protective covers.