VDL25BM
- 1 -
VELLEMAN
VDL25BM(R) – BUBBLE MACHINE
1. Introduction & Features
At the end of its life cycle, dispose of this product in accordance with local and national disposal
regulations. Read the manual thoroughly before bringing this device into service
Thank you for buying the
VDL25BM
! Make sure there is no damage caused by transportation. Should there be any,
don’t install or use the device and consult your dealer. The
VDL25BMR
has a remote control with a cable of 7m.
2. Safety Instructions
Be very careful during the installation: touching live wires can cause life-threatening electroshocks.
Unplug the mains lead before opening the housing.
•
Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the dealer will
not accept responsibility for any ensuing defects or problems.
•
A qualified technician should install and service this device.
•
Do not switch the device on immediately if it has been exposed to changes in temperature. Protect the device
against damage by leaving it switched off until it has reached room temperature.
•
This device falls under protection class I. It is therefore essential that the device be earthed. Have a qualified
technician install this device.
•
Make sure that the available voltage does not exceed the voltage stated in the specifications of this manual.
•
Do not crimp the power cord and protect it against damage. Have an authorised dealer replace it if necessary.
•
Always disconnect the device from the mains when it is not in use or when you wish to clean it. Handle the power
cord by the plug only.
•
There may be some smoke or a particular smell when the device is activated for the first time. This is normal and
any smoke or smell will gradually disappear.
•
Never leave the bubble machine running unattended and aim the muzzle away from those present. This device is
not suited for continuous operation.
•
Always make sure there is enough bubble liquid in the tank. Always use an appropriate liquid and don’t heat it.
•
All modifications of the device are forbidden for safety reasons. Damage caused by such modifications is not
covered by the warranty. Keep the device away from children and unauthorised users.
3. General Guidelines
•
This device is designed for professional use on stage, in discos, theatres, etc. The
VDL25BM
should only be used
indoors with an alternating current of max. 230V AC/50Hz.
•
Do not shake the device. Avoid brute force when installing or operating the device.
•
Select a location where the device will be protected against extreme heat, moisture and dust. Install it in a well-
ventilated area and do not install any other devices within a 30cm radius of the
VDL25BM
.
•
Use an appropriate safety cable to fix the device (e.g.
VDLSC7
or
VDLSC8
).
•
Familiarise yourself with the functions of the device before actually using it. Do not allow operation by unqualified
persons. Any damage that may occur will most probably be due to unprofessional use of the device.
•
Use the original packaging if the device is to be transported.
•
Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks, crash,
etc. Using the device in an unauthorised way will void the warranty.
