25
Beechcraft Bonanza 15e ARF Assembly Manual
□□
Step 4
Use a 5/64-inch drill bit to enlarge the inner hole in
the servo arm.
□□
Step 4
Remove the flap servo mounting template from page
55 of the manual. Use a hobby knife to trim around
the outside of the template and remove the sections
marked with an ‘X’.
□□
Step 5
Place the template on the inside of the flap servo
hatch and use a pencil to mark the mounting block
locations.
□□
Step 6
Mix a small amount of 12-minute epoxy and glue the
servo mounting blocks in place.
□□
Step 7
Set the servo in place between the mounting blocks
and use a pencil to mark the mounting hole
locations.
Note:
for both left and right flap servos the output
shaft is located towards the leading edge and right
wing tip.
Note:
It may be necessary to carve a relief in one of
the blocks to provide clearance for the servo lead.
Use a hobby knife to do so if required.