Trumpeter 03217, Instructions Manual

Page: 1 / 16

1/32 scale
ITEM NO.:03217
TA
Junkers Ju-87DStuka
tJu-87D( 4
READ BEFORE ASSEMBLY:
• Toolsrecommended(notincludedinkit):Plasticandinstant HER#DTB fT#iái tE O.
• JHIF HF#, F F#.
• This kit is not recommended for inexperienced modelers
cements,sprue cutters, long nose pliers,,modeling knife,
small files, tweezers, pin vise & scissors. Soft cloth and
sandpaper will also assist in construction
Glue and paint are not included in the kit. Use plastic
cement and hobby paints only. Color guide for purchasing
paint is included in the kit.
Keep out of reach of small children. They must not be
allowed to ingest small parts or handle plastic bags in
any way.
or for children under 14 years of age
• Study and understand these instructions thoroughly
before beginning assembly
• When needed, remove photo-etch parts carefully using
•##NIN(H) : Bk. ķ IJ, K
J)
a modeling knife or photo etch sprue cutter, being careful
not to damage or lose small parts.
• Take extra care in handling photo etch parts in order to
avoid injury
• Apply instant cement sparingly to photo etch parts where
instructed
kRiANE#:
DECAL APPLICATION:
4. While still wet,decal can be adjusted for
.AKEE# FEDE;
better fit on model by dampening it gently
with your finger.
1.Cut decals from sheet as needed
.$)ERA*109, AREF Ħ E. 2. Dip the decal in warm water for about 10
*EDEAA%EDEBIWVE;
Cyanoacrylate glue Weight
Make hole Cut/ Remove
seconds and then place on soft clean cloth. 5. When placed in the proper position,gently
press decal down with a soft cloth until
excess water and air bubbles are gone.
3. Hold the decal backing sheet edge and
gently slide the decal onto the model in its
proper position.
.#4ABEEDÆAEKT, AAH*. 6. Allow decal to dry completely before handling
model
Decal File / Sand Option
No cement
Bend
03217 1