Dynapac PL2000F, Инструкция по эксплуатации

Страница: 183 / 283

Operation
172 4812313240.pdf
2017-12-1
Once all the preparations for milling are complete,
the machine is ready for milling, the automatic
levelling device is activated from the main control
panel and the machine is lowered to the depth
required while at a standstill.
- Release control lever (3) by pressing slide
switch and gently slide forwards out of central
point (within dead band range).
- At the same time, use the function key (4) of
the control lever panel control down so that
the machine dips into a horizontal position
and in its final position is tilted slightly more at
the rear than at the front.
This milling position should be retained during the
entire milling process, even if the milling depth is
changed via the digital controller.
- Set the max. milling speed required by
pressing button (24) or (25).
The machine starts to move:
- Depending on the setting, the speed display
lights up.
The speed reached is shown on the display.
Other settings can also be made on the leveling
equipment.
4 24 25
3
Fig. Switch panel, ergo control
panel