Dynapac PL2000F, Инструкция по эксплуатации

Страница: 143 / 283

Machine description
132
4812313240.pdf
2017-12-1
Milling depth display
One milling depth display, indicating cm
and/or inches, is located on both sides of the
milling housing. This provides additional
visual assistance in addition to the leveling
equipment.
- The upper edge of the side shield serves
as a reference and indicates the depth of
the engaged milling drum on the display
(1).
Milling drum operational check
Several control marks can be found on both
side shields and, depending on the grating
depth, indicate the extent to which the milling
drum is engaged.
The control marks are used as assistance, e.g.
if milling is to be conducted as close as
possible to an obstacle (e.g. drain cover).
- Control marks are available for the
following milling depths: 4 cm (1), 10 cm (2),
20 cm (3), 30 cm (4).
‐ The slots in the side shield under the
marks are used as a reference line and
indicate the minimum possible distance
between the milling drum and obstacle at
which no damage will be caused.
Fig. 1.Milling depth display
Fig. Depth
1. 4 cm
2. 10 cm
3. 20 cm
4. 30 cm
1 2 3 4
1