Dynapac PL2000F, Инструкция по эксплуатации

Страница: 102 / 283

Machine description
91
4812313240.pdf 2017-12-1
(Page 302)
Press button D to set parameters of
working device in page 301.
It is required to select parameters needed to
be changed first.
The red frame indicates the focus point, press
button D to move to the next parameter
box.
1. Button on the display. Select corresponding button for each specific action.
2. Action menu, corresponding button on the display (1) which controls selecting
each action.
And then rotate knob A (see Knob A location from Welcome screen description)
to change the corresponding parameters, the step pitch is 1%.
Press button B to enter and save, and the focus frame changes from red
into green.
The parameters in the conveyor from top to bottom are in the following order:
- forward speed percentage;
- reverse speed percentage;
- delay time percentage of control handle back to neutral position.
The parameter of water pump:
- water volume control percentage;
- delay time percentage of control handle back to neutral position.
The pressures are of sliding shoe and scraper and side plates respectively.
Press button G to return to page 301.
3. Information screen, show action selection result from the information screen.
Electrical screen (Page 401)
The upper part of screen displays the double
circuit voltage of potentiometer in X-axis and
Y-axis of control handle on the right arm control
box of the machine.
The lower part of screen displays the
potentiometer voltage in X-axis and Y-axis of
steering handle of right drive unit on the right
control box of the machine.
1 2
B
C
D
E
F
G
3
B
C
D
E
F
G