Dynapac PL2000F, Инструкция по эксплуатации

Страница: 52 / 283

Machine description
41
4812313240.pdf
2017-12-1
- a large return suction filter, fitted in the hydraulic
oil tank, for the drive circuits of the traction unit,
loading belt, fan and water system as well as for the
drives of the cylinder adjustment functions;
- two pressure filters, fitted in front of the milling
drum housing, on the right under the machine and
easily accessible from the outside. In the drive
circuit for height adjustment and steering, these are
switched between the load-sensing adjustment
pump and the hydraulic control blocks.
Electrical system: 24 volt system with two cold
start high power batteries engaged sequentially.
The power supply can be interrupted to
ground/earth by the battery’s main switch.
Air pressure system (optional): Compressor
driven directly by the engine with compressed air
reservoir of 20l/6.3 bar. There is a connection point
with a rapid release clutch for external consumers
(e.g. pneumatic milling tool driver or rotary
screwdriver) in the rear section under the machine.