Dynapac PL2000F, Инструкция по эксплуатации

Страница: 184 / 283

Operation
173
4812313240.pdf 2017-12-1
Stop the machine and raise at the end of the
milling track:
Depending on the milling depth, the end of the cut
will be at the height of the reference point marked
on the side boards:
-To remove the milled material from the conveyor
belts, let the lower and discharge conveyors run
on as is necessary.
The run-on times can be set in the lower and
discharge conveyor menu.
- Smoothly raise the machine by operating
joystick (1) or button (2), (4) of the main
control panel.
- Pressing button (7), (8), (9) of the rear
side ground plate control until the distance
required between the machine and ground is
reached.
Never fully raise the machine for driving purposes!
Risk of tipping!
- Slightly raise sliding shoe by pressing button
(32).
- Slightly raise scraper board by pressing button
(34).
- Set both front and rear tracker back to neutral
position.
See button function description from “Machine
description” chapter.
7 8 9
24 32 34 25 1 2 4
Fig. Switch panel, ground plate
control