Dynapac PL2000F, Инструкция по эксплуатации

Страница: 181 / 283

Operation
170 4812313240.pdf
2017-12-1
Milling (preparation)
- Drive the machine to the milling section and
lower manually as far as possible (side boards are
lowered, milling drum does not quite touch the
ground)
‐
Correct start position with the help of the
reference points on sideboards for various
milling depth (4,10,20,30 cm)
Example: Milling starts
Once the milling drum has been inserted to the
milling depth of cm required, exactly on the rear
dimension mark.
‐
Switch the A/M button of the digital controller
of the levelling system („AUTO“ function
lights up).
‐
Set milling depth and / or slope on levelling
display. (Precondition: the zero and/or actual
value calibration has already been conducted).
Please refer to the description of levelling
system from “ Machine description ” Chapter.
- Lower the machine, by pressing the joystick (4)
of the control lever panel, via the rear strut
towers until the base-plates of the side boards
touch the ground in the rear area.
4