Dynapac PL2000F, Инструкция по эксплуатации

Страница: 67 / 283

Machine description
56 4812313240.pdf
2017-12-1
Pos. Designation Symbol Brief description
1 Ignition lock
Insert the key and turn it to the right, the vehicle is
supplied with power. When resetting, the vehicle
is powered off and the engine stop working.
2
Emergency
stop
Press in emergencies (people in danger, risk of
collision etc.)!
- The engine, drive units and steering are
disengaged whenever the EMERGENCY STOP
button is pressed.
No movement, e.g. of the lower conveyor, is then
possible! Risk of accident!
- Seven emergency stops are located on the
left/right console, ergo box and four ground plate
control boxes respectively. Any of it being
pressed shall be indicated in the display.
- To restart the engine, all EMERGENCY STOP
buttons must be in the upright position.
3
Engine
start/stop
engine
Start engine by pressing the switch when the
ignition lock is switched on (Safety condition is
required, refer to the module description). LED
indicates activation.
The display will show the reason for unsuccessful
start of engine. Press the switch to stop engine
when it is in operation.
4 Service mode
At the touch of the button, the system enters into
the service mode, LED lights up, exits by
pressing it again.
The button/mode function is activated only when
the engine is started and the planer is in
stationary.
In service mode:
- The engine speed value can be set directly by
using button 24 & 25.
- The planer stays in braking mode, and the
travelling function is deactivated.
- Both of the side boards can stay in any position.