Dynapac PL2000F, Инструкция по эксплуатации

Страница: 95 / 283

Machine description
84 4812313240.pdf
2017-12-1
4. The actual torque load of engine is shown in percentage.
5. The level of water tank is indicated by instrument graphics.
6. The level of diesel oil is indicated by instrument graphics.
7. The engine alarm information is shown at the right corner of display.
Mainly include:
Engine fault alarm Lit effect
Engine warning alarm Lit effect
Engine regeneration Lit effect
Engine regeneration prohibition Lit effect
High post-processing temperature of engine Lit effect
Low DEF liquid level of engine Lit effect
1
st
BOX: Display status: Alarm display OR Normal display
2
nd
BOX: Drive Forward mode OR Neutral position OR Reverse
mode
4. The engine speed in rpm is shown on the left side of display (instrument graph).
5. The actual driving speed is shown on the right side of tachometer, with the
measuring range of 99, and unit of m/min (feet in British system). The maximum
setting speed is displayed under the meter of actual travelling speed, with the
unit of m/min (feet in British system). During the transport runs, the display
shows actual road speed in km/h (mile in British system). The maximum
achievable road speed goes out at this time.
6. The total distance travelled by the machine since delivery is indicated at bottom
right of the display (the value, with the unit of km, cannot be reset to zero), and
the measuring range is 99999, recalculate from 0 when it overflows.
7. The total distance travelled in milling mode is shown below the total mileage
(recalculate when it is cleared to zero).Callout the main screen, press button G
for more than three seconds and then reset mileage. And it is recorded only
when the plan is in low speed working mode (turtle), the milling drum is turned
on and the automatic state is valid. The measuring range is 99999, and
recalculates from zero after it overflows.
8. The actual torque load of engine is shown in percentage.
9. The level of water tank is indicated by instrument graphics.
10. The level of diesel oil is indicated by instrument graphics.