Chapter 2 Installing InterPBX Communication System
21
Installing VG5000/VG6000 Voice Gateway
Figure: VG5000 Voice Gateway Connection Diagram
Figure: VG6000 Voice Gateway Connection Diagram
Installing and Configuring VG5000 Voice Gateway
1. Connecting to Power Cord
Plug one end of the power cord to the power connector on the rear panel of the
VG5000. Plug the other end of the power cord into a power outlet. After you
turn on the power switch on the rear panel, you can verify the function by
checking if the LED labeled Power is on.
2. Connecting to LAN
You can connect VG5000 to your existing Ethernet network. Please connect one
end of the Ethernet cable to the network RJ45 port of VG5000 and connect the
other end of the Ethernet cable to any 10/100BaseT RJ45 port on DSG SH2500
Switching Hub or your existing switching hub.
3. Connecting to Trunk Lines or Analog Extensions
VG5000 supports trunk lines and analog extensions. Please plug the trunk line
from the Central Office to the CO Line port or plug the analog extension to the
SLT port.
NOTE
: Misplacing FXO equipment into FXS interface and vice versa may
damage your VG5000 Voice Gateway. Be sure that the FXO/FXS interfaces of
VG5000 are connected to suitable telephone lines and equipment.
