16
Chapter 2 Installing InterPBX Communication System
Installing and Configuring Blaze/Savanna Server
1. Connecting to Power Cord
Plug one end of the power cord to the power connector on the rear panel of
Blaze/Savanna Server. Plug the other end of the power cord into a power outlet.
After you turn on the power switching on the rear panel, you can verify the
function by checking if the LED labeled “Power” is on.
2. Connecting to LAN
You need to connect Blaze/Savanna Server to your existing Ethernet network.
Connect an Ethernet cable from the “Network” RJ45 port on Blaze/Savanna
Server to any 10/100BaseT RJ45 port on a switching hub.
3. Connecting to CO Lines or Extension Lines (For Blaze Series Only)
With Blaze Series, the Server is integrated with Voice Gateway module. Voice
Gateway supports CO line or analog extension modules. Please plug a CO line
connector to a CO Line port or plug an analog extension to a SLT port.
NOTE
: If you accidentally plug the equipment with CO Line interface to SLT
port, it may damage your equipment. Please make sure that your equipment
connects to an appropriate interface. About the external audio connector or
broadcasting equipment, please refer to Chapter 2 Install VG5000/VG6000
Voice Gateway.
4. Preparing a Computer
Prepare a computer with web browser and be sure it is on the same subnet as of
your Blaze/Savanna Server. Change the computer’s IP settings if necessary. The
suggested web browser is Internet Explorer version 5.0 or later.
The default values of Blaze/Savanna Server are as follows:
Default IP Address: 192.168.1.200:88 (The service port is 88)
Default Gateway: 192.168.1.254
Default Subnet Mask: 255.255.0.0
5. Login Blaze/Savanna Server
