Docomo Foma SH905iTV, Инструкция по эксплуатации

Страница: 61 / 579

e03_dt20_7e.fm
[59/86]
59
Continued on next page
Vo
ic
e/Vi
d
eop
ho
ne
C
all
s
5
Receive image icon
6
Call duration
Approximate call duration appears on the screen. When the call
duration exceeds 9:59:59, the display resets to 0:00.
7
DTMF mode icon
8
Hands-free icon
9
Earpiece volume icon
Calls may be interrupted even when the signal is strong (
]
appears) and you are not moving.
To call selecting Multi Number
n
P. 423
To call selecting a number when the 2in1 is used
n
P. 424
1
In stand-by, enter a phone
number.
Always enter the area code even when the
number is in the same area.
Enter up to 80 digits for phone number.
To erase the last digit: Press
c
.
To erase all digits: Press
c
(for 1+
seconds).
2
Press
s
(Phone)/
i
(V.phone).
Unlike ordinary telephones, mobile phones send call tones in
short beeps before the standard ring tone.
When the other party is busy, there is a busy signal. Disconnect
and try again later.
Operation during a voice call
To display your own phone number: Press
C /
[Own number].
To enable/disable Hands-free: Press
s
(for 1+ seconds).
Operation during a Videophone call
To display your own phone number: Press
C /
[Own number].
To enable/disable Hands-free: Press
s
.
To switch between Substitute image and My side: Press
i
.
To set light: Press
C /
[Videophone]
/
[Lighting].
To send touch-tone signals while sending a camera image:
Enter numbers to send.
To send touch-tone signals while sending a Chara-den: Press
C /
[DTMF mode]
/
[ON]
/
enter numbers to send.
3
Press
H
to end the call.
6
Appears while sending a still picture as a substitute
image
9
Appears while sending an image from My picture of
Data box
!
Appears when shooting and saving images of the
other party
7
ON
8
OFF
5
(red)
Hands-free in progress
6
(green) USB hands-free in progress
.
v
(Volume 1) to
@
(Volume 10)
Note
The display brightness during a Videophone call follows the
setting of Original Eco mode in Light/Power saver.
Making calls/Videophone calls
Note
When the 2in1 mode is set to [Dual mode], the screen for selecting
a phone number appears after step 2. Select the phone number
from [Number A]/[Number B].
dt20_E.book 59 ページ ２００７年１２月２５日 火曜日 午後２時２２分