Docomo Foma SH905iTV, Инструкция по эксплуатации

Страница: 257 / 579

e11_dt20_7e.fm
[255/260]
255
Continued on next page
i-
a
pp
li
Note
Only one software can be set as i-
a
ppli stand-by.
Some software cannot be set as i-
a
ppli stand-by.
If i-
a
ppli stand-by is set, i-
a
ppli appears as stand-by. The image
set as the stand-by display of Set screen does not appear. If
i-
a
ppli stand-by is disabled, the image set as the stand-by display
of Set screen appears.
Web To functions are not available from i-
a
ppli stand-by.
If software that transmits data is set as i-
a
ppli stand-by, the
software may not operate properly depending on the signal
strength.
If All lock is set when in i-
a
ppli stand-by, i-
a
ppli stand-by screen
closes and [ 待受画面 1] image appears.
When the FOMA terminal is set to the Cycloid position, it appears
in the horizontal screen. [This software cannot use in a horizontal
position] appears, and the software is interrupted depending on
the i-
a
ppli software. Return to the normal position to resume the
software.
If i-
a
ppliDX is set as i-
a
ppli stand-by, the i-
a
ppliDX software may
transmit data to verify the validity of the software regardless of the
software transmission setting.
If i-
a
ppli stand-by is set, the i-
a
ppli stand-by confirmation screen
appears when the handset is turned on. Select [Yes] or do nothing
for approximately 5 seconds to start i-
a
ppli stand-by. Select [No]
to show normal stand-by and cancel i-
a
ppli stand-by settings. If
the handset is turned on by the Auto power ON setting, the
confirmation screen does not appear and i-
a
ppli stand-by starts
when the stand-by display reappears.
i-
a
ppli stand-by is not available when the 2in1 mode is set to [Dual
mode] or [B mode].
The following operations end stand-by i-
a
ppli.
Security errors
While i-
a
ppli stand-by is set, if an incorrect i-
a
ppli action is
attempted, or use of a function not permitted is attempted, i-
a
ppli
stand-by is disabled.
If an error that cancels i-
a
ppli stand-by occurs, the error time and
other information appear and are recorded in the error history. No
information is recorded when ended properly. When [Security
error] appears in stand-by, press
t
to view the error history.
Related Operations
Set whether to transmit data from i-
a
ppli stand-by
<Stand-by NW set>
In the software list, select software set as stand-by
/
C /
[Stand-by NW set]
/
select the setting
/ t
.
Note
Camera Updating software
Data box iC transmission
i-mode Ir exchange
Mail Downloading i-
a
ppli
Videophone Starting i-
a
ppli
Data Security Service Manga&BookReader
SD-Audio Document Viewer
Changing i-
a
ppli settings PDF Viewer
Playing i-motion 1Seg
ToruCa Updating pattern definitions
Changing 2in1 (switching modes, switching ON/OFF of 2in1 function)
dt20_E.book 255 ページ ２００７年１２月２５日 火曜日 午後２時２２分