Docomo Foma SH905iTV, Инструкция по эксплуатации

Страница: 348 / 579

346
e15_dt20_7e.fm
[346/356]
Data Display
/Ed
it/Man
age
m
en
t
Start i-
a
ppli software that supports Ir remote control functions, point
the FOMA terminal’s Ir port to the front of the remote control sensor on
the TV, VCR or other device to operate, and perform remote control
operations.
Actual operational methods will differ with each i-
a
ppli software application.
Control devices from a distance of up to approximately 4 m (Distance will
vary depending on the device, the ambient brightness and other factors).
Use iC transmission to send and receive data to and from
other FOMA terminals which also support iC transmission
function.
During iC transmission, the FOMA terminal status is the same as
when outside the service area, such that making/receiving calls,
i-mode, and data communications are not possible.
iC transmission is not available during a call.
iC transmission is not available while the IC card is locked.
Data that can be sent and received or operations when various lock
functions are set are same as for Ir exchange (
n
P. 341).
Procedures for starting iC transmission from i-
a
ppli
n
P. 259
Use while placing FeliCa mark (
b
) of receiving side FOMA
terminal on that of sending side FOMA terminal.
Do not move the FOMA terminal until all data are sent and received.
Remote control operation
Note
When in the Self mode, the Ir remote control function cannot be
used.
Depending on the device, operation may not run properly.
Remote control operation may not run properly directly under
fluorescent lights, near other equipment using infrared signals, or
in areas of direct sunlight.
15°
Approx. 4 m
15°
Infrared port
iC transmission
iC transmission
Precautions for using iC transmission function
FeliCa mark
dt20_E.book 346 ページ ２００７年１２月２５日 火曜日 午後２時２２分