DHS Systems 1003080, Техническое руководство

Страница: 119 / 136

Operation & Maintenance Medium SXGA+ Projection System 0016
Part Number 1006380 0016-5 DHS Systems LLC
This document contains information proprietary to DHS Systems LLC and is intended solely for use by its customers. No portion of this document may be reproduced
for release to a third party without written consent of DHS Systems LLC.
CLEANING THE MEDIUM SXGA+ PROJECTION SYSTEM PROJECTOR
INITIAL SETUP:
Tools and Special Tools
References
Damp Cloth
Vacuum
Materials/Parts
Equipment Condition
Water Equipment Powered Down
Power Source Disconnected
WARNING
Voltage sources, in addition to being an electrical shock hazard, may also potentially produce
serious burns. Care should be exercised when using water around exposed power connections.
Ensure that all power to the system has been shut off before cleaning the Projector. Never open
the Projector, as this will void any warranties.
CAUTION
Use of a damp cloth is authorized for cleaning the Projector’s exterior body only and care should
be exercised to ensure no liquid enters the inside of the Projector. Allow the Projector to air dry
before applying power.
CAUTION
The Projector Len is sensitive to scratches. Only use lens cleaning tissue to prevent scratches to
the Projector Len. Replace Len cap when not in use.
SERVICE
1. Verify that the Medium SXGA+ Projection System has been shut down and the power source has been
disconnected.
2. Disconnect all cables from the Projector.
3. Inspect the exterior body of the Projector for damage.
4. Clean the exterior body of the Projector using a damp lint free cloth with clean water.
5. Use a vacuum to clean all the air vents to maintain sufficient air flow.
6. Use lens cleaning tissues to clean the lens. Replace lens cap when not in use.
END OF TASK