DHS Systems 1003080, Техническое руководство

Страница: 45 / 136

Operation & Maintenance Medium SXGA+ Projection System 0005
Part Number 1006380 0005-11 DHS Systems LLC
This document contains information proprietary to DHS Systems LLC and is intended solely for use by its customers. No portion of this document may be reproduced
for release to a third party without written consent of DHS Systems LLC.
Frame Disassembly Procedures
33. Disconnect all power and video cables from the rear of the projector and remove from frame.
34. Holding the projector in place, loosen projector mounting clamp and lower projector. Install lens cap and place
projector into transport case.
35. Using clean hands or gloves, remove the projection screen from the screen frame by unsnapping at each snap.
Do not grab the projection screen by the corners and pull off of the screen frame. This will cause snap or
projection screen damage. Follow the Projection Screen Folding Instructions on the next page.
36. Ensure personnel are clear from area below projector support arm. Disconnect the adjustable steel cables (12) at
the projector support arm (11) (see Figure 7) and slowly lower the projection support arm. Remove projector
support arm and adjustable steel cables and place in transport case.
37. Remove both upper (5) and lower (6) support crossbar (see Figure 3) from frame (1) and place in transport case
38. Unlock all support braces (3), retract four folding legs (2) and collapse the screen frame (1) as shown in Figure
13. Place folded screen frame into the transport case.
2
1
2
3
4
4
4
4
3
3
3
3
3
3
3
Figure 13. Collapse Screen Frame.