DHS Systems 1003080, Техническое руководство

Страница: 84 / 136

Operation & Maintenance Medium SXGA+ Projection System 0008
Part Number 1006380 0008-16 DHS Systems LLC
This document contains information proprietary to DHS Systems LLC and is intended solely for use by its customers. No portion of this document may be reproduced
for release to a third party without written consent of DHS Systems LLC.
Factory reset
Factory reset erases all memorized
source and system settings, and sets
all back to default values.
Service
Service enters the service menu. This
is available to authorized service
personnel only. Entering the service
menu without proper knowledge may
permanently damage the projector.
Remote control ID
The projector can be set up to have a
unique ID, so that it only responds to
remote controls transmitting the same
ID. Up to 99 units can be handled
without interfering with each other,
using the same remote. By default, the
projector is set to respond to any one
remote control, thus is set to
“broadcast”. To change, and set a
unique ID, select, and change the
value with the left / right arrow keys.
To set the remote control to broadcast
to a specific ID, press the asterisk key
(“*”), and enter a number that
corresponds with the projector you
wish to control using the numeric
keypad. When pressing the asterisk
key towards a projector, it will respond
with its unique ID, and prompt the user
to enter a matching one.
DPMS
Enable or disable the DPMS (Display
Power Management Signaling). When
enabled, the projector will
automatically switch to standby mode
after a specified time if there is no valid
source present at its inputs. When a
valid source is reconnected, the
projector will start up again.
DPMS timeout
DPMS can be set from 1 – 180
minutes. Default is 30 minutes.