DHS Systems 1003080, Техническое руководство

Страница: 36 / 136

Operation & Maintenance Medium SXGA+ Projection System 0005
Part Number 1006380 0005-2 DHS Systems LLC
This document contains information proprietary to DHS Systems LLC and is intended solely for use by its customers. No portion of this document may be reproduced
for release to a third party without written consent of DHS Systems LLC.
MEDIUM SXGA+ FRAME ASSEMBLY PROCEDURES
WARNING
The screen surface must be stored in its pouch when not in use to
prevent damages. If stored at temperatures far below room
temperatures, allow the screen to warm up to room temperature before
unfolding. This will ensure the film is being handled in its most flexible
state and will prevent surface cracks.
WARNING
There are seventeen pivot (pinch) points located around the frame
assembly.
Assemble Frame
1. Locate and place both transport cases in the area where the Medium SXGA Display is to be setup.
2. Open the transport case that contains the frame components and unload contents onto ground in work area.
3. Expand screen frame (1) to open position. Ensure frame hinges and corner support braces are securely latched
as shown in Figure 1.
4. Extend four folding legs of frame (2). Ensure folding leg support braces (3) are locked (see Figure 2).
5. Use the rubber feet (4) on the folding legs (2) of screen frame (1) to compensate for uneven floor surface.
2
1
2
3
4
4
4
4
Figure 2. Expand Screen Frame.