DHS Systems 1003080, Техническое руководство

Страница: 111 / 136

Operation & Maintenance Medium SXGA+ Projection System 0014
Part Number 1006380 0014-1/2 blank DHS Systems LLC
This document contains information proprietary to DHS Systems LLC and is intended solely for use by its customers. No portion of this document may be reproduced
for release to a third party without written consent of DHS Systems LLC.
OPERATOR MAINTENANCE INSTRUCTIONS
MEDIUM SXGA+ PROJECTION SYSTEM
PMCS INTRODUCTION
GENERAL
This Work Package provides data necessary to keep the DC2E Medium SXGA+ Projection System operational ready.
PMCS are performed to keep the equipment in operational condition. The checks are used to find, correct, and report
problems. Personnel trained on the equipment are required to perform the tasks as indicated in Operator PMCS (WP
0015), Table 1. PMCS are performed by the operator each time the equipment is operated.
WARNINGS AND CAUTIONS
Special attention should be paid to the WARNINGS and CAUTIONS appearing in the operator PMCS table. A
WARNING means someone could be injured. A CAUTION means equipment could be damaged.
EXPLANATION OF TABLE ENTRIES
Item Number – Numbers in this column are for reference. When completing DA Form 2404/ DA Form 5988E
(Equipment Inspection and Maintenance Worksheet), include the item number for the check/service indicating a fault.
Item numbers appear in the order in which the checks/services are performed for the interval listed.
Interval – This column indicates when a procedure must be performed (i.e., Before, During, or After an operation).
Item to Be Checked or Serviced – This Column identifies the item that is to be checked or serviced.
Procedure – This column describes the procedure that must be followed to ensure that the equipment is capable of
performing its intended mission.
Equipment Not Ready/Available If – This column lists conditions that make the Medium SXGA+ Projection System not
fully mission capable. If the problem can be fixed using the troubleshooting procedures and/or maintenance
procedures in this manual, do so. If not, document the items not able to be fixed on DA Form 2404/DA Form 5988E
for operator maintenance. For further information on how to use this form, see DA PAM 750-8. Be sure to observe
and annotate all special circumstances that appear/occur.
NOTE
Perform weekly as well as before PMCS if you are the assigned operator but have not operated the
equipment since the last weekly inspection, or if you are operating the equipment for the first time.
If the equipment must be kept in continuous operation, only perform those procedures that will not
disturb operation. Complete checks and services when the equipment is shut down.
END OF WORK PACKAGE