Delta VFD-ED Series, Руководство пользователя

Страница: 237 / 389

Ch12 Descriptions of Parameter Settings | VFD-ED
12-26
7
Over-torque (OT1)
(Pr.06-05–06-07)
Active when detecting over-torque. Refer to Pr.06-05 (over-torque
detection-OT1), Pr.06-06 (over-torque detection level-OT1) and
Pr.06-07 (over-torque detection time-OT1).
8
Over-torque (OT2)
(Pr.06-08–06-10)
Active when detecting over-torque. Refer to Pr.06-08 (over-torque
detection-OT2), Pr.06-09 (over-torque detection level-OT2) and
Pr.06-10 (over-torque detection time-OT2).
9 Drive is ready Active when the drive is ON and no error detected.
10
User-defined low-voltage
detection
Active when the DC bus voltage is too low (see Pr.06-00 Low voltage
level).
11
Malfunction indication Active when a fault occurs (except Lv stop).
12
Mechanical brake release
(Pr.02-29, Pr.02-30, Pr.02-37)
When the drive runs according to Pr.02-29, it is ON. Use this function
with the DC brake. It is recommended to use contact “b” (N.C).
13
Overheat (Pr.06-14)
Active when IGBT or heat sink overheats. To prevent OH, turn off the
drive (refer to Pr.06-14).
14
Brake transistor signal
Activated when the drive needs help braking the load. This function
helps achieve a smooth deceleration (refer to Pr.07-00).
15
Motor-controlled magnetic
contactor output
Active when you set MI function to #40 (Enable drive function).
16
Slip error (oSL) Active when the slip error is detected (according to Pr.05-14).
17 Malfunction indication 1 Activate after 10 ms when a fault occurs (except Lv stop).
18 Reserved
19
Brake transistor output error Active when a brake transistor error is detected
20
Warning output Active when a warning is detected.
21 Over-voltage warning Active when an over-voltage is detected.
22
Over-current stall prevention
warning
Active when an over-current stall prevention is detected.
23
Over-voltage stall prevention
warning
Active when an over-voltage stall prevention is detected.
24
Operation mode indication
Active when the operation command is controlled by an external
terminal (Pr.00-15=1).
25 Forward command Active when the operation direction is forward.
26
Reverse command Active when the operation direction is reverse.
27
Output when current
≥
Pr.02-33
Active when current is
≥
Pr.02-33.