DATREND Systems vPad-A1, Руководство по эксплуатации

Страница: 65 / 108

vPad-A1 OPERATORS MANUAL
Note
: To add a new
Manufacturer
,
Model
, or
Sensor
not found in the
existing options, refer to section 4.8.2.3 -
Calibration: SpO2 R-
Curves
.
Contained within the
Manufacturer
menu is an item called
Favourites
, which is a
custom list of frequently-tested
Models
. By default, the
Favourites
category is
empty. To add a new item to the list, first select the desired
Model
as shown in
Figure 66
.
Next, touch the icon near the top right corner of the screen. The icon
launches a
Favourites Editor
, displaying items currently in
Favourites
. The “Add”
button will enter the selected
Manufacturer
and
Model
(plus
Sensor
if applicable)
into the list as a new item.
To delete an existing item from the list, highlight an item as shown in
Figure 67
,
then touch the “Remove” button. When finished, press “Exit” to dismiss the
Favourites Editor
. All added items will be listed in the
Favourites
category under
Manufacturer
.
4.6.3 Parameters
4.6.3.1 Blood Oxygen Saturation
The target
Blood Oxygen Saturation
(
SpO2%
) setting changes the saturation
reading expected on the
DUT
. It can be modified over the range of 30 % to
100 %, in 1 % increments.
Note
: Not all pulse oximeters are able to produce reliable measurements at
low to very low
SpO2%
(i.e. less than 70%). See section 4.8.2.3 -
Calibration: SpO2 R-Curves
for more information regarding
oximeter specifications and restrictions to saturation range.
4.6.3.2 Heart Rate
The
Heart Rate
parameter sets the frequency of pulse waveforms for
SpO2
. It can be set from 20 to
300 beats per minute (BPM), in increments of 1 BPM.
4.6.3.3 Pulse Amplitude
The
Pulse Amplitude
parameter controls the relative size of the simulated plethysmogram. It can be
set from 0 % (no pulse) to 100 % (normal adult pulse), in steps of 1%.
Figure 67
Figure 68
Manual Operation/Chapter 4
#
Page 51