Cumberland PRO-VISION, Руководство пользователя

Страница: 15 / 55

15
PRO-VISION rev.04
PRO-VISION
Temp.
Sensors
Heater
Unused Fans Unused Fans
Unused Fans
Unused Fans
Clean Mode
Heaters
Heater
Heaters
Temp.
Sensors
Temp. Sensor
Select: 1.
Main menu
* Start Flock
* A password may be required to access this menu
(see section 4.2.1).
Start flock
To modify use -
Mortality
Loss (%)
Stat Flock
Age
Clean Mode
Remaining
Birds placed
Age
Program
New Mortality
Alarm low T°?
0
0.00
No
1
On
10000
10000
Program 1
0
No
Set the following parameters: 2.
Clean Mode — Select
“On”
to enable the clean
mode or select
“Off”
to disable it.
Alarm low T° — Select
“Yes”
for the controller
to set off an alarm when the average tempera-
ture gets lower than the
Non Brood Set Point
while the controller is in clean mode. *
This
parameter is accessible if the clean mode is enabled
above or if an empty zone is used.
Figure: Heaters in Clean Mode
4.9. Test Mode
The test mode is used to simulate changes in
the ambient temperature and verify the control-
ler’s performance. When the test is enabled, all
outputs of the controller operate according to
the simulated temperature. The test automati-
cally ends after 15 minutes of inactivity or if
the user deactivates it manually.
Select: 1.
Main menu
* Set-up
Test Mode
* A complete-access password may be required to
access this menu (see sec. 4.2.1).
Test Mode
Program
Temperature
Status
Stat.Pressure
Program 1
0.0
Off
0.00
Set the following parameters: 2.
Program # — This is the program that is cur-
rently used by the controller. It is displayed for
information only. *
Refer to section 4.3 to change
the program in use.
Status — Select
“On”
to enable the test mode
or select
“Off”
to disable it.
Temperature — Set the simulated room tem-
perature to the desired value. * This parameter
is accessible if the test mode is enabled above.
Stat. Pressure — This is the current level of
static pressure. It is displayed for information
only and cannot be modified manually. *
This
parameter is accessible if the test mode is enabled
above and if a static pressure sensor is enabled in
the Set-up menu (see section 4.4).
4.10. Version
The version menu gives the version number
of the program used by the controller. This
piece of information is useful to get techni-
cal support.
Select: 1.
Main menu
* Set-up
Version
* A complete-access password may be required to
access this menu (see sec. 4.2.1).
Pro-vision
V X.X
Build no. XXXX
Released: Jan 1 200X