Convotherm 4 Table-Top, Руководство по эксплуатации

Страница: 139 / 144

6.3.3 Replacing the oven light halogen lamp
For your safety when performing maintenance
Before starting any maintenance work, familiarize yourself with the rules, risks, and hazards specified
in 'Working Safely When Performing Maintenance' on page 136 and follow all the corresponding in‐
structions without exception.
Procedures that you must be familiar with
You will need to be familiar with the following steps:
■
Safely Opening and Closing the Unit Door 60
■
Removing and Installing the Racks 80
■
Using the Transport Trolley to Put Food Inside the Oven and Take It Out (Does Not Apply to
ConvoSmoke) 71
Spare parts included
As indicated in the spare parts list, the required spare part is:
■
One (1) 12 V halogen lamp
Required tools
You will need the following tools:
■
Socket wrench with a width across flats of 8 mm
Handling the halogen lamp
Always wear clean gloves when grabbing halogen lamps (alternatively, you can use a cloth). Do not
touch the bulb in new halogen lamps, or halogen lamps that you will be reusing, with your bare fingers.
If the halogen lamp cannot be removed completely, e.g., the terminals are stuck, contact a service
technician immediately.
Prerequisites
Check whether the following prerequisites are met:
■
The combi steamer has been de-energized and locked and tagged out.
■
The oven cavity must have cooled down to a temperature of less than 60 °C since the last time it
was used.
■
In the case of units with a rack: The right-hand side rack has been swung towards the inside of the
oven cavity.
■
In the case of units with a mobile shelf rack / plate rack (does not apply to ConvoSmoke): The mo‐
bile shelf rack / plate rack and the roll-in frame must have been taken out from the oven cavity.
■
The halogen lamp has already cooled down.
■
The new halogen lamp has been inspected for damage and is not damaged.
6 How to Perform Maintenance on the Combi Steamer
Operating Manual 139