134
97.
Press the applicable number(s) to turn the
data results “on” or “off.”
98.
Press the operation key below NEXT
PAGE to access additional serial data
options.
99.
Press the operation key below PREV
PAGE to return to the Setup screen.
100. Press “4” to access the Unit Serial Number
screen.
Note: If the instrument, due to component
failure, etc., cold starts, the instrument serial
number will be erased from the instrument
software. The serial number can be found on the
instrument nameplate on the back of the
instrument and reentered into the software.
101. Using the operation keys below the arrows,
select the first letter of the serial number.
102. Press ENTER.
103. Continue using the operation keys to select
each letter and number of the serial
number. Press ENTER after each seletion
until the entire serial number is selected.
104. Press READY to return to the Setup
screen.
105. Press “5” to access the Calibrate Intelli-
Temp screen.
Note: The SMART System
5
is completely
factory calibrated. Calibration of the Intelli-Temp
is not necessary prior to system use. Calibration
is recommended only for verification of system
operation or if a problem with calibration is
suspected. Refer to the Maintenance, Trouble-
shooting and Service section of this manual for
calibration procedures.
106. Press EXIT to return to the CEM Main
Menu.
SERIAL DATA OPTIONS
1. DILUTION RATIO:
ON
2. TSS/TVSS RESULTS:
ON
3. DELTA WEIGHT:
ON
4. DELTA TIME:
ON
5. FAT DELTA WEIGHT: ON
6. FAT DELTA TIME:
ON
7. % ASH:
ON
Press item number to select.
MAIN
PREV
MENU
PAGE
Setup
1. COMPANY NAME
2. DELETE METHOD
3. SERIAL OPTIONS
4. UNIT SN
5. CALIBRATE Intelli-Temp
Press item number to select.
PREV
PAGE
UNIT SN:
0
1 2 3 4 5 6 7 8 9 A B
C D E F G H I J K L M N
O P Q R S T U V W X Y Z
Space
Delete
Highlight choice, press ENTER.
Press READY to continue.
➞
➞
➞
➞
Setup
1. COMPANY NAME
2. DELETE METHOD
3. SERIAL OPTIONS
4. UNIT SN
5. CALIBRATE Intelli-Temp
Press item number to select.
PREV
PAGE