Carbide 3D Shapeoko 4 XXL, Инструкция по сборке

Страница: 7 / 43

S T E P 2
S T E P 2 – Y ‑ R a i l s
10 docs.carbide3d.com support@carbide3d.com 11
2.2 Install Y‑Left Rail
1. Position the Y-Left extrusion rail on the four
standoffs on the left side of the baseframe.
See Fig. 2-2 .
a. Shapeoko 4 decal to inside-front.
b. V-rail to outside.
Figure 2-2
2.3 Install Y‑Right Rail
1. Position the Y-Right extrusion rail on the four
standoffs on the right side of the baseframe.
See Fig. 2-2 .
a. Carbide 3D/flag decal to inside-front.
b. V-rail to outside.
2. Use a 5mm hex key and four (4) M6×85mm
shoulder bolts to loosely attach the Y-Right rail
to the standoffs. See Fig. 2-2 .
Figure 2-3
a. Insert bolts in order: front, back, center.
b. Ensure bolts fit snugly into the lower
through-holes with the shoulder flush
against the rail as shown in Fig. 2-3 .
c. Snug the bolts, then back out ¼ turn.
2. Use a 5mm hex key and four (4) M6×85mm
shoulder bolts to loosely attach the Y-Left rail
to the standoffs. See Fig. 2-2 .
a. Insert bolts in order: front, back, center.
b. Ensure bolts fit snugly into the lower
through-holes with the shoulder flush
against the rail as shown in Fig. 2-3 .
c. Snug the bolts, then back out ¼ turn.