Carbide 3D Shapeoko 4 XXL, Инструкция по сборке

Страница: 18 / 43

S T E P 5
S T E P 5 – X / Z A s s e m b l y
32 docs.carbide3d.com support@carbide3d.com 33
Figure 5-6 Figure 5-8
4. Thread the belt, teeth down, under the two
idlers on the back of the X/Z carrier plate.
5. Use a small hex key to pull a large loop of belt
up between the two idlers and into the motor
housing. See Fig. 5-6 .
6. Position the X-motor over the threaded screw
holes on the motor housing. See Fig. 5-7 .
a. Motor pulley faces into motor housing and
under the belt loop.
b. Motor lead cables extend up.
7. Use a 4mm hex key and four (4) M5×12mm
SHCS to secure the X-motor to the motor
housing. Fully tighten. See Fig. 5-7 .
8. Pull the slack out of the belt.
a. Look through the slot in the top of the
X-motor housing to make sure the belt
stays properly on the motor pulley.
9. Thread the second belt clip onto the free end
of the belt. (Refer back to 5.5 Attach Belt Clip
to Belt , if necessary.)
10. Hold the clip flat against the end of the X-rail.
11. Adjust the length of the belt so that there is a
2–3mm gap between the clip and the Y-Right
carriage plate. See Fig. 5-8 .
12. Use a 4mm hex key and one (1) M5×12mm
SHCS to secure the clip.
a. Maintain downward pressure on the clip.
b. Fully tighten the screw until the belt snaps
back against the rail when gently lifted.
NOTE: Do not overstretch the belt. Stretching
more than 3mm could damage the belt or motors.
Figure 5-7