Carbide 3D Shapeoko 4 XXL, Инструкция по сборке

Страница: 5 / 43

S T E P 1
S T E P 1 – B a s e f r a m e
6 docs.carbide3d.com support@carbide3d.com 7
1.2 Position Crossmembers
and Drag Chain Support Panels
1. Place a drop of Loctite on the threads of one
standoff.
2. Locate the two threaded holes on each end of
a crossmember without standoffs.
3. Screw the standoff into the inner-most of the
two threaded holes.
4. Repeat steps 1–3 to install the three (3)
remaining standoffs.
a. Each crossmember will have 2 standoffs.
b. Standoffs will all line up.
Figure 1-2
1.3 Assemble Baseframe
1. Use a 4mm hex key and eight (8) M6×6mm
BHCS to loosely attach the support panels to
the crossmembers. See Figs. 1-2 and 1-3 .
a. Snug the screws, then back out ¼ turn.
b. Don’t worry about squaring the baseframe
yet.
Figure 1-3
1.4 Install Cable Tie Mounts
1. Use a 2mm hex key and four (4) M3×6mm
BHCS to secure two (2) cable tie mounts to
each support panel. See Fig. 1-3 .
a. Secure mounts to the wide-set M3
integrated nuts toward the back.
5. Position the four crossmembers horizontally
across your table. See Fig. 1-2 .
a. Standoffs up, about 10 inches apart.
6. Check each standoff and make sure each is
finger-tight.
7. Position the two support panels, face up, front
to back, across the outside edges of the four
crossmembers. See Figs. 1-2 and 1-3 .
a. Look for outline of nuts to identify back—
they are pressed into back-side of panel.
b. M3 integrated nuts to the outside.
c. Two close-set M3 nuts toward the front.
d. Two wide-set M3 nuts toward the back.