Carbide 3D Shapeoko 4 XXL, Инструкция по сборке

Страница: 22 / 43

S T E P 5
S T E P 5 – X / Z A s s e m b l y
40 docs.carbide3d.com support@carbide3d.com 41
Figure 5-16 Figure 5-17
8. Place the loop over the stepper motor pulley.
See Fig. 5-16 .
9. Thread the second belt clip onto the free end
of the belt.
10. Place the belt clip on the Y-Left rail at the
back-left endplate.
a. The small slotted tab faces the INSIDE.
11. Hold the belt clip flat against the rail.
12. Adjust the length of the belt so that the small
slotted tab sits over the M3 screw hole in the
rail and the M3 screw hole is at the back-most
edge of the slot.
13. Use a 2.5mm hex key and one (1) M3×6mm
BHCS
to LOOSELY secure the belt clip to the
M3 hole in the top of the rail.
14. Use a 4mm hex key and one (1) M5×12mm
SHCS to secure the clip to the back-left
endplate. Fully tighten. See Fig. 5-17 .
15. Use a 2.5mm hex key to fully tighten the M3
BHCS on the top of the rail.
a. The M3 screw head should now be in the
middle of the slotted tab.
NOTE: The belt will snap back against the rail
when gently lifted. Do not overstretch the belt as
this could damage the belt or motors.
5.13 Install Y‑Right Belt
1. Repeat all steps in 5-12 to install the second
Y-Axis belt to the Y-Right rail.
NOTE: The Y-Right belt clips will be opposite
those on the Y-Left rail. The small slotted tabs will
always face to the INSIDE of the machine.
2. Plug the Y-Left stepper motor extension cable
into the Y-Left motor cable. See Fig. 5-18 .
Figure 5-18