Carbide 3D Shapeoko 4 XXL, Инструкция по сборке

Страница: 29 / 43

S T E P 7
S T E P 7 – R o u t e r
54 docs.carbide3d.com support@carbide3d.com 55
7.7 Install X‑Axis Drag Chain
1. Position the X-Axis drag chain along the top of
the X-Axis gantry.
a. Head of the drag chain attaches to the
head bracket. See Fig. 7-9 .
b. Body of the chain extends right from the
head bracket before curling down and left,
ending just before the Y-Left carriage.
Figure 7-8
7.6 Attach Transition Bracket
to Y‑Axis Drag Chain Head
1. Position the X/Y transition bracket on the head
of the Y-Axis drag chain. See Fig. 7-8 .
a. Head of the chain is closest to the router.
b. Flat side of the head of the drag chain
attaches to the two integrated nuts in the
bracket arm.
c. Router cable must enter the chain OVER
the bracket arm and through the opening
where the first link hinge was removed.
Figure 7-9
2. Use a 2mm hex key and two (2) M3×6mm
BHCS to secure the bracket to the drag chain
head. Fully tighten.
7.8 Secure X‑Axis Drag Chain
Head and Tail
1. Use a 2mm hex key and two (2) M3×6mm
BHCS to secure the drag chain head to the
router head bracket. Fully tighten.
2. Position the tail of the X-Axis drag chain over
the two M3 integrated nuts at the Y-Left end
of the X-Axis drag chain support panel. See
Fig. 7-9 .
3. Use a 2mm hex key and the two (2) M3×6mm
BHCS to secure the tail to the support panel.