Carbide 3D Shapeoko 4 XXL, Инструкция по сборке

Страница: 24 / 43

S T E P 6
S T E P 6 – D r a g C h a i n
44 docs.carbide3d.com support@carbide3d.com 45
Figure 6-2
6.2 Install X‑Axis Drag Chain
1. Position X-Axis drag chain along the top of the
X-Axis gantry. See Fig. 6-2 .
a. Head of the chain to the left; the tail to the
right, ending at the Y-Right carriage.
b. Head has all female connectors.
c. Head curls up and attaches to the head
bracket.
Figure 6-3
6.3 Secure X‑Axis Drag Chain
Head and Tail
1. Use a 2mm hex key and two (2) M3×6mm
BHCS to secure the X-Axis drag chain to the
data drag chain head bracket. Fully tighten.
See Fig. 6-2 .
a. Data drag chain head bracket is the
shorter bracket.
2. Position the tail of the X-Axis drag chain over
the two M3 integrated nuts on the right side
of the X-Axis drag chain support panel. See
Fig. 6-3 .
3. Use a 2mm hex key and two (2) M3×6mm
BHCS to secure the tail of the X-Axis drag
chain to the support panel. Fully tighten.