Carbide 3D Shapeoko 4 XXL, Инструкция по сборке

Страница: 19 / 43

S T E P 5
S T E P 5 – X / Z A s s e m b l y
34 docs.carbide3d.com support@carbide3d.com 35
Figure 5-9 Figure 5-10
5.7 Install Data Drag Chain
Head Bracket
1. Position the (shorter) data drag chain head
bracket on the BACK of the X/Z carrier plate
(see Fig. 5-9) :
a. Align to the two (2) M5 holes in the upper-
right corner (from the rear).
b. Flange down.
2. Use a 3mm hex key and two (2) M5×6mm
BHCS to secure the bracket to the
X/Z assembly. Fully tighten.
5.8 Install Router Drag Chain
Head Bracket
1. Position the (longer) router drag chain head
bracket on the BACK of the X/Z assembly (see
Fig. 5-10) :
a. Align to the two (2) M5 holes in the upper-
left corner (from the rear).
b. Flange down.
2. Use a 3mm hex key and two (2) M5×6mm
BHCS to secure the bracket to the
X/Z assembly. Fully tighten.