Carbide 3D Shapeoko 4 XXL, Инструкция по сборке

Страница: 17 / 43

S T E P 5
S T E P 5 – X / Z A s s e m b l y
30 docs.carbide3d.com support@carbide3d.com 31
Figure 5-4 Figure 5-5
5.5 Attach Belt Clip to Belt
See Fig. 5-4 .
1. Thread about 2 inches of belt through the
outer slot of the clip, with teeth facing toward
the integrated nut.
2. Loop the belt down through the inner slot and
pull the belt tight against the clip.
3. Bring the two sections of belt together.
Interlock the teeth and extend the belt away
from the integrated nut.
5.6 Install X‑Motor and Belt
1. Locate the X-Axis belt kit.
a. Contains two identical universal belt clips.
2. Thread one end of the belt through a belt clip.
(Refer back to 5.5 Attach Belt Clip to Belt , if
necessary.)
3. Use a 4mm hex key and one (1) M5×12mm
SHCS to secure the belt clip to the top of the
Y-Left carriage. See Fig. 5-5 .
a. Slotted end of the clip against the rail.
b. Ensure belt teeth interlock where they
meet at the clip.
c. Ensure teeth face down as the belt
extends along the X-rail.
d. Insert SHCS through the outside of the
carriage plate.
e. Fully tighten.