Carbide 3D Shapeoko 4 XXL, Инструкция по сборке

Страница: 27 / 43

S T E P 7
S T E P 7 – R o u t e r
50 docs.carbide3d.com support@carbide3d.com 51
7.2 Install Router Mount
1. Position the router mount over the four screws
holes at the bottom of the Z-carriage. See
Fig. 7-2 .
a. Two larger M6 mounting holes on top.
2. Use a 5mm hex key and two (2) M6×40mm
SHCS to secure the top of the mount. Fully
tighten.
3. Use a 4mm hex key and two (2) M5×40mm
SHCS to secure the bottom. Fully tighten.
Figure 7-2
7.3 Install Router
1. Insert the router as far as it will go into the
mount, with the power cable extending left.
2. If the router doesn’t quite fit, use a 3mm hex
key and the M6 grub screw to gently pry open
the mount. See Fig. 7-4 .
a. Insert the grub screw into the center
threaded hole on the front-right of the
mount.
b. Tighten until the opening is just wide
enough to insert the router.
c. Remove the grub screw.
Figure 7-3
3. Use a 5mm hex key and two (2) M6×25mm
SHCS to secure the router in the mount. Fully
tighten. See Fig. 7-3 .
a. Insert screws into the top and bottom
through-holes on the front-right of mount.
b. Alternate tightening each screw until the
router is secure.
Figure 7-4