Carbide 3D Shapeoko 4 XXL, Инструкция по сборке

Страница: 34 / 43

S T E P 9
S T E P 9 – C o n t r o l l e r
64 docs.carbide3d.com support@carbide3d.com 65
9.3 Install Controller
1. Position the controller over the two M6
integrated nuts on the front of the controller
mount.
a. Power and USB to the back.
See Fig. 9-3 .
b. PCB will be upside down.
2. Use a 4mm hex key and two (2) M6×6mm
BHCS to secure the controller to the controller
mount. Fully tighten.
9.4 Attach Grounding Wire
1. Place the end of the green grounding wire on
the end of the M6×12mm BHCS set aside in
step 9.2.
2. Use a 4mm hex key and the M6×6mm BHCS
to secure the back end of the controller mount
and the grounding wire to the support panel.
Fully tighten. See Fig. 9-3 .
Figure 9-2 Figure 9-3
9.2 Install Controller
Mount
1. Remove the two rear M6×6mm BHCS
from the Y-Right drag chain support
panel.
2. Locate the controller mount set aside
from the step 1 box.
3. Position the controller mount so the
M6 through-holes in the base of the
mount are aligned with the two rear
through-holes in the support panel. See
Fig. 9-2 .
a. Mount’s flange faces to the INSIDE.
4. Use 4mm hex key to insert one (1) M6×12mm
BHCS to secure the front end of the base of
the mount to the support panel.
a. Set aside the second M6×12mm BHCS; it is
needed in step 9.4.