Carbide 3D Shapeoko 4 XXL, Инструкция по сборке

Страница: 39 / 43

S T E P 1 0
S T E P 1 0 – S e t U p M a c h i n e ‑ C o n t r o l S o f t w a r e
74 docs.carbide3d.com support@carbide3d.com 75
10.6 Set Up BitSetter
Accessory (Optional)
If you also purchased the optional BitSetter
accessory, you’re ready to set it up. BitSetter is an
automatic tool offset probe which measures the
length of each tool. BitSetter makes it easy to run
jobs using multiple tools without the need to stop
and re-zero your Z-Axis manually.
First, position the router above the BitSetter (
see
Figs. 10-5 and 10-6) :
1. Click Jog in the top menu bar.
2. On the Jog screen , click the Set Zero button .
3. Click the Clear All Offsets button and then
click Done .
4. On the Jog screen , click the Rapid Position
button .
5. Click the SE button to move the router to the
front-right corner of the machine.
6. Once machine is in position, click Done .
7. On the Jog screen , use the Y+ / Y- and X+ / X-
buttons (or the arrows on your keyboard) to
jog the gantry so the router is directly above
the BitSetter trigger button. See Fig. 10-6 .
Figure 10-5
Next, configure the permanent position of the
BitSetter in Carbide Motion ( see Fig. 10-6) :
8. Click Settings in the top menu bar.
9. Click the Options tab in the Settings menu.
10. In the BitSetter section , select the Enabled
checkbox .
11. Click the Use Current Location button to save
the X/Y location of your router.
12. Click Ok to save and close.
10.7 Set Post Processor in
Carbide Create (Optional)
Carbide Create must have the post processor set
to Carbide 3D Shapeoko for the optional BitSetter
accessory to work. To set the post processor:
1. Open Carbide Create.
2. Go to
Edit in the top menu bar.
3. Choose Select Post Processor , then choose
Carbide 3D Shapeoko .
4. In the Output Units dropdown list , select Inch
or Metric .
5. Click OK to save and close.
Figure 10.6